IPS Weld-On #16 Plastic Glue Cement for Acrylic Plexiglass 5 oz. Tube 16

Description

Item description:
5 oz. Weld-On #16 Plastic Glue Cement Tube for Acrylic Plexiglass
SUBSTRATE RECOMMENDATIONS
WELD-ON 16 is especially formulated to bond acrylic plastic. It can also be used for bonding styrene, butyrate, PVC and polycarbonate, as well as other plastics and porous surfaces.
BONDING RECOMMENDATIONS
WELD-ON 16 is recommended as an excellent general purpose, high strength acrylic cement. It is especially useful where fast cure and high strength are desired for applications such as large housings, signs, plastic letters, industrial fabrications, display items, lenses and models.
GENERAL DESCRIPTION
WELD-ON 16 is a very high strength, clear, medium bodied, fast curing, bodied solvent-type acrylic cement. Applied to cast, molded or extruded acrylics, it will effect initial bonds within minutes and form strong joints within hours.This product may be thinned with WELD-ON 3 by approximately 10%. Initial bond forms very quickly so some parts may be handled within a few minutes of application. Bond strength continues to develop very rapidly reaching a substantial level within hours. Joints are water and weather resistant and will generally have similar physical and chemical properties to acrylic plastic.
BOND STRENGTH DATA
The following strength data was obtained with compressive shear loading at 0.05/min.The materials tested were acrylic lap joints of 1 sq. in. bonding area.
SUBSTRATE MATERIAL 24 HOURS 1 WEEK
Acrylic 1700 PSI 2200 PSI
Polycarbonate 1000 1700
Styrene 900 1700
ADHESIVE PROPERTIES AND CHARACTERISTICS
COLOR: Clear
VISCOSITY: 800 cps
WORKING TIME: 2 _ 3 minutes
FIXTURE TIME: 5 _ 6 minutes
80% STRENGTH: 16 hours
SPECIFIC GRAVITY: 1.02 ± .040
COVERAGE: 10mil: 28sq. ft./Pint 224 sq. ft./Gallon
20mil: 14sq. ft./Pint 112 sq. ft./Gallon
DIRECTIONS FOR USE
1. Parts to be joined should be clean and fit without forcing.
2. Apply WELD-ON 16 to one or both surfaces with brush, polyethylene squeeze bottle or gun.
3. If cement is applied to one surface, bring the two surfaces in gentle contact for several seconds to allow the dry surfaces to be softened.
4. Assemble with firm pressure while parts are still wet.
5. Hold or clamp assembled parts firmly until initial set. Joint strength will increase greatly in 24 hours.
Thereafter, strength will continue to increase gradually for some weeks.
SHELF LIFE
Two years expectancy in tightly sealed containers. Stability of the product is limited by the permanence of the container and the evaporation of the solvent when container is open. Evaporation of solvent will cause the cement to thicken and reduce the effectiveness of the cement.